Back when I was Tattooing, I typically liked to use a newly built Machine for a minimum of 3 hrs, even better to get 5 hrs of run time on it.
This gives the Springs & the Contact Screw time to properly bed in & run smoothly, also everything needs to be checked just to be sure nothing is coming loose.
So given this newly built Magnum Machine has only had about 1 hour of running under load (that's actual Tattoo time), I really wasn't that surprised when
Donny said that the Machine was no longer working.
Donny had the Machine & was about to start another Tattoo when suddenly it sounded very strange...
...a quick glance revealed that it had broken a Front Spring. (aka Top Spring)
Obviously I'm going to need to change that Spring, but that's all I'll be doing to the Machine at this point.
Some old advice for young players out there:To isolate the cause of a problem, you only change one thing at a time.
Too many changes that are done all at once, means you'll never know exactly what caused that original problem.
Chances are that everything will run sweet again & this new Spring will be there for many years to come.
If this newly replaced Spring breaks again within a short space of time, it'll mean there's a bigger problem & I'd need to start looking at the other possible causes.
Possible causes:It's been about 16 years since I last built a Machine & in some cases my original sources for components that I preferred to use are no longer around.
Of course this now presents me with a number of problems to consider & overcome.
- Finding a new source for the component.
- Establishing if this totally new component will match up to my original needs.
- Will it run correctly with everything else.
- Will it last the distance.
In this case, the Spring material is one of those new components so it's quite possible I've over stressed it, causing it to fail.
I'll only know this by replacing the Spring, running it in again & seeing if it fails for a second time.
If it did, then I might also need to consider changing to a different source for my Spring material.
So there's a few more tests awaiting this Machine...